 鲜花( 6)  鸡蛋( 0)
|
本帖最后由 craigliu 于 2011-3-13 12:10 编辑
2 Y8 c: Z" j2 {8 g4 l8 ], S1 v6 _( Q2 L) `0 T% e
"打算把这个硬盘拆下来连到另一台电脑上,可是怎么才能连上呢?".
" r* a+ a! P- o+ |+ U1) Open case, you usually need to open two sides. 2 {1 f/ v& J; t X) u! M$ M7 a2 x6 T
2) unplug cables that attached to the HD. Usually there are two cables (one for power, one for data).& q3 m, E# a7 |9 F% d2 D
3) unscrew for HD.: f0 w& z0 \" C3 D# l$ R
4) take out HD." I) w3 X4 A* R, p3 E1 d
5) Usually The HD is set as Master, and you need to reset jumper pin into Slave. There is a label on the HD that indicators how you set jumper pin.
6 w1 N' e7 d! E. t/ ]" f$ Q6) open the case of another computer.
4 `9 y# Y, g) T& |. z7) Connect all cables. (two cables. Only correct cable can be plugged. So just try, if you can plug in, it is right cable.)7 B7 [6 V' Q) i; d- M
8) start computer.1 E$ P7 e, D( M" k; N
G2 Q0 Y3 T: |. \! I
(I suppose you use the HD that was popular before, because you use XP.) |
|