 鲜花( 6)  鸡蛋( 0)
|
本帖最后由 craigliu 于 2011-3-13 12:10 编辑
/ c4 j9 h2 y% b m- X$ E6 l' m1 l! P; S
"打算把这个硬盘拆下来连到另一台电脑上,可是怎么才能连上呢?".
* O, Y b$ z; @% ?1 l$ s1) Open case, you usually need to open two sides.
: d8 a) k6 O8 t2) unplug cables that attached to the HD. Usually there are two cables (one for power, one for data). b( g% S( a c0 _2 ~, ^9 L
3) unscrew for HD.
8 h1 @6 h9 T9 Z, ?, j4) take out HD.5 l. d* s5 k- r& {/ \4 b: r1 x
5) Usually The HD is set as Master, and you need to reset jumper pin into Slave. There is a label on the HD that indicators how you set jumper pin. 6 F- D, V7 Q: E+ s
6) open the case of another computer.4 x8 j: _" M2 r* b6 D
7) Connect all cables. (two cables. Only correct cable can be plugged. So just try, if you can plug in, it is right cable.)
# G7 d# \) W9 |: @8) start computer.
0 z/ ?5 @$ _7 n* A$ s9 [5 [% g1 c5 X M
(I suppose you use the HD that was popular before, because you use XP.) |
|