 鲜花( 7)  鸡蛋( 0)
|
Cantruss, 俺来说两句。。。。哎哟，谁在扔砖头？！
"Cantruss", as well called as "Uni-strud", or "C channel", is a very commonly used industrial/commercial standard framing/supporting material, usually used to make a sort of brackets as a support to Cable Tray by using spring nuts and bolts, or use "P Clamp" to hold pipes/conduits/cables, even sometime are used to bolt onto another material directly. ' S1 \6 h$ x+ h7 }: b I
0 w5 U: g: |5 W
the most commonly used size of cantruss also called standard cantruss has its dimension of 2 5/8" by 1 7/16", with holes bored on either side or just a whole piece. other than that, we also use "shallow cantruss", which is half the depth of standard size or "double cantruss", which is pre-manufactured two standard cantruss simply back to back welded together.
. U- P; m; P j- F8 K
4 w2 R) E+ F5 w5 z8 E' LMost cantruss are made by steel, however, we do see aluminum cantruss some time as well, for an instance, the rung or a ladder tray.' c6 Z3 t8 i; [- [! T4 a( v
; c) a, _ [% t" [) V
The best way to cut a contruss is by using chop saw, however chop saws are banded on some jobsite in Alberta, which is very wired. other means of cutting a contruss might be band saw, sawsall(reciprocating saw), or hydraulic cantruss cutter. Hacksaw does work as well, by you might need a little bit musle!
, T; f. n$ D9 L
8 ^) f# q! S+ m) _Most common ways to put cantruss together is by welding, drill hole and bolt it together, or using some pre-fabricated "T" or "L" shape joiners) P# L& o; d6 X1 w) c2 p
. ) z2 A9 q. Y: u) E* T
Steel cantruss is usually galvanized for corrosion resistance, but the galvanize also causes some problem and generate poison gas when welding . So, remember to grind the galvanize off about half inch back at either end of the welding points before you deliver it to a welder will be highly appreciated by welders.
- v5 D, i4 N8 ]# F& g- T
- }- @, y; M5 r& g9 VO me O my, am I taking too much? Gotta shut up to get my jaw a rest!!!!!!! T/ p# \, a: K0 w- `# u! `
r* w% ` q- r, G
Have a good nite, bye bye...! a* P, Z! Q1 ]( ?9 e
/ O( @3 r/ x6 V1 z' O) [. r9 H1 Mshut up.....$ m! ?( I% |, x' I) n" Q
" K( _" A" g. _5 l: W
sorry... |
|
狗仔卡
发表于 2009-1-16 14:16
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
显身卡
发表于 2009-1-19 16:24
