 鲜花( 242)  鸡蛋( 8)
|
本帖最后由 白马啸西枫 于 2009-12-31 21:24 编辑 3 z1 ]3 m+ [9 D& C( u3 q1 w9 H) |4 e
4 j: T6 k$ J: Q3 I+ @5 \ 22# 小黄 : |$ S( P& L/ t+ X$ Q6 r5 T
8 J" `( w- d6 Z- |, y
小黄,你说得对,但不全面。- ]5 C+ |% j$ b+ ~
overdrive 档是汽车的最高档,也叫超速挡,超比档,正如shark 27所说: 此时的引擎曲轴转一圈时,齿轮箱的输出轴却可转超过一圈。对引擎而言,就是输出轴端的扭力变小了:
! m+ `$ I. ~2 I& E, o以下摘自维基百科:$ [, m5 z. Y; d3 E- l+ M3 O; i, N
超比(省油)档开关(O/D):自动变速器的最高档通常是超比档,该档位齿轮比(减速比)低于一,也就是该档位将引擎扭力放大倍数变成低于一倍,有助于省油,但不利于加速。超比开关关闭后,D档行驶时,自动变速器将无法换入超比档。通常在上坡及路面状况不良时应考虑将此开关关闭。
- q5 S# W% [* V( h6 m0 @! ~* g3 MA unit with a planetary gearset which turns the driveshaft faster than the transmission output shaft.3 V, e+ t% m8 {5 E/ s
An additional gearbox which is mounted in the driveline. Normally the final drive ratio is 1:1; but the overdrive makes it less (e.g., 0.87:1). The overdrive can reduce gas consumption at sustained high-speed driving, engine noise, and engine wear. Also called "overdrive transmission." Also see aftermarket overdrive
% _1 z2 X( s9 _+ w2 c( uGearing in which less than one revolution of a transmission's input shaft causes one turn of the output shaft. The purpose of overdrive is to reduce engine rpm in high gear for better fuel economy. Example: A transmission with an overdrive top gear has a ratio of 0.70 to one. Turning the input shaft 0.7 revolutions causes 1.0 revolution of the output shaft.: ^" H) @$ m+ z i0 j+ t
因为输出轴端的扭距变小,所以变速箱的设计师有意将其设计成超车时踩油会降档,以提高变速箱输出端的扭距离和加速度,从而使汽车更快地加速。 |
|